Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

vlans

why is it when I do a show vlan I see all the vlans that are available and active(i'm not refering to the standard default one), but when I do a show int vlan xxx on each Vlan I can not see all of them

2 REPLIES
Hall of Fame Super Blue

Re: vlans

Hi

This is because "sh vlan" lists the vlans that have been created at layer 2.

sh int vlan xxx shows the L3 interfaces that have been created for the layer 2 vlans.

It is perfectly possible to have layer 2 vlans created on a switch that do not have a corresponding layer 3 interface.

HTH

Jon

Silver

Re: vlans

Hi ,

Show vlan shows all the vlans configured on the switch.....Suppose in case of trunk link b/n switches you can able to see all the vlans allowed over the trunk link.

show int shows only the specific interface stats..

if you wabt to see partuclar valn stats you can use show vlan command.

it will not show the vlans configured on the switch or vlans allowed over the trunk..

Thanks,

satish

202
Views
0
Helpful
2
Replies
CreatePlease to create content