02-16-2014 06:34 PM - edited 03-10-2019 12:25 PM
Hi,
I have a VLSM question as follow:
The base address given is 10.1.0.0/23:
Required:
1) 6 hosts and 7 subnets
2) 2 hosts and 6 subnets
Can anyone help me out on this?
Thanks
02-16-2014 06:39 PM
Edit on the requirements:
Require:
1) 6 hosts in each 7 subnets
2) 2 hosts in each 6 subnets
Thanks
02-16-2014 06:58 PM
for 6 hosts in each subnet you can use multiple /29
example:
10.1.0.0/29 useable host 1-6
10.1.0.8/29 useable hosts 9-14
10.1.0.16/29 useable hosts 17-22
10.1.0.24/29 useable hosts 25-30
10.1.0.32/29 useable hosts 33-38
10.1.0.40/29 useable hosts 41-46
10.1.0.48/29 useable hosts 49-54
for 2 hosts you can use /30s
10.1.0.56/30
10.1.0.60/30
10.1.0.64/30
10.1.0.68/30
10.1.0.72/30
10.1.0.76/30
HTH
02-16-2014 07:32 PM
Thanks Reza for the quick reply. Just to double check that the second VLSM subnet is correct?
As from /29 (first subnet) to /30 (second subnet) there is only 1 bit change (below table the 30th bit) thus the valid range for second subnet can only be: 10.1.0.56/30 and 10.1.0.60/30.
10 | 1 | 0 | 56 | |
0000 1010 | 0000 0001 | 0000 0000 | 0011 1000 | 10.1.0.56/30 |
10 | 1 | 0 | 60 | |
0000 1010 | 0000 0001 | 0000 0000 | 0011 1100 | 10.1.0.60/30 |
Plaese advice.
Thanks
02-17-2014 04:10 AM
Not sure what you mean when you say -
thus the valid range for second subnet can only be: 10.1.0.56/30 and 10.1.0.60/30.
Alain's answer is correct, all the /30 subnets he has posted can be used.
Jon
02-17-2014 04:20 AM
Hi Jon,
Thanks for referencing me even if I did nothing on this post
Regards
Alain
Don't forget to rate helpful posts.
02-17-2014 04:24 AM
I'm getting old.
Apologies Reza, my mistake.
Jon
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: