10-31-2006 03:06 PM - edited 03-05-2019 12:33 PM
Hi:
just wanna ask a an example of complete voice vlan config for the Cisco-3750 and Cisco-3560 switches.
Does Voice VLAN also requires and IP just like Access VLAN?
Example:
int vlan 10
ip address 10.220.10.254 255.255.255.0
Thanks
Cliff
10-31-2006 03:19 PM
Hi Cliff ,
Complete config for voice vlan for 3560 link is below.
Complete config for voice vlan for 3750 link is below.
Hope this helps you a lot.
Thanks,
satish
11-02-2006 05:25 AM
Hi:
I can't access the link. its asking for CCO account.But ill just ask one question,if access vlan interfaces needs ip address inorder for the hosts to have it as a gateway, does the voice vlan also must have?
thanks
11-02-2006 05:38 AM
Hi ,
Voice VLAN is only supported on access ports and not on trunk ports, even though the configuration is allowed.
The sample config of voice vlan config is
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# mls qos trust cos
Switch(config-if)# switchport voice vlan dot1p
Switch(config-if)# end
In which Valn id is Valid VLAN IDs are from 1 to 4094.vlan-id?Configure the Cisco IP Phone to forward all voice traffic through the specified VLAN.
You should configure Valn so that all voice traffic is passed through that vlan.
Thanks,
Satish
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: