Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

voice vlans

Hi all, quick question, if im using vlan 10 as my data vlan and vlan 11 for my voice, how do i make sure that the data vlan 10 is being used when i issue the voice vlan 11 command ?

5 REPLIES
VIP Purple

Re: voice vlans

The configuration varies by switch. See below for variations.

Cat 4k/6k

set vlan 10 5/1

set port auxiliaryvlan 5/1 11

Catalyst 3500 and Etherswitch module

switchport mode trunk

switchport trunk encapsulation dot1q

switchport trunk native vlan 10

switchport voice vlan 11

Catalyst 3550/3560

switchport access vlan 10

switchport voice vlan 11

Hope this helps. If so, please rate the post.

Brandon

Community Member

Re: voice vlans

Hi There, thanks for that, what if I have say 4 different data vlans on the same switch for each dept for example? what would i do here as they all cant be native ?

VIP Purple

Re: voice vlans

This is a per port configuration, so 1 vlan will be native on each port.

On a trunk port, you can set the vlans that are allowed with the following command.

switchport trunk allowed vlan

If you ? after this command, you will see that you have several options for allowing vlans.

Hope this helps.

Brandon

Community Member

Re: voice vlans

So could I on my port have say

switchport access vlan 50

switchport voice vlan 10

?

VIP Purple

Re: voice vlans

Yes, definitely.

Brandon

156
Views
7
Helpful
5
Replies
CreatePlease to create content