VPC not comming UP after switch reboot 5K (qosmgr type-1 configuration incompatible)
when we started to do some failover test we have found out that our VPC is not getting up.... We are getting qosmgr type-1 configuration incompatible when running command sh vpc consistency-parameters global. After putting down VPC and bringing it up all is working just fine. When we have rebooted second switch we did not observer such an issue.
I reviewed whole config no inconsistancy found :(
Can someone advice where to look?
Hardware: cisco Nexus5548
Software BIOS: version 3.6.0 loader: version N/A kickstart: version 6.0(2)N2(5) system: version 6.0(2)N2(5)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...