Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

VPN encrypt

Hi again, another simple question here, I managed to setup a VPN between my home PC and my office router. All works well, I finally stopped pulling my hair out and managed to gain access to my 10.x.x.x network from outside.

Just for security purposes, I would like to encrypt that connection. I followed a tutorial found on cisco website, but the command "ppp encrypt" gives me a syntax error on my 1760 router. I type "ppp en?" and no choice comes up, so I did all the steps of the tutorial except this one.

Releavant part of my config:

!

vpdn-group 1

! Default PPTP VPDN group

accept-dialin

  protocol pptp

  virtual-template 1

!

username user1 password 0 xI6L7/^i5}bywLyI

!

interface Virtual-Template1

ip unnumbered FastEthernet0/0

peer default ip address pool vpn-pool

no keepalive

ppp authentication ms-chap ms-chap-v2

!

ip local pool vpn-pool 10.3.0.1 10.3.255.255

What am I missing?

Thanks !

205
Views
0
Helpful
0
Replies
CreatePlease to create content