Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VPN failover Design !

hi all, i would like to get some guidance on the VPN failover design, just like we do in BGP where the neighbours form neighbour relationship with each others loopback addresses, can we do the same in site to site VPN ? like both of the peers form vpn on some GLOBAL ip ( like ip on loopback or ethernet interface ) so that if 1 of the link goes down vpn is not disrupted..

Any idea ??

4 REPLIES

Re: VPN failover Design !

New Member

Re: VPN failover Design !

Dear Andrew, i am not looking for a new type of vpn :) i am looking for a failover design for site to site vpn only ...

Any idea ??

Re: VPN failover Design !

What is you corrent VPN hardware? Are you running a dynamic routing protocol? What layer 3 routing devices are you running?

New Member

Re: VPN failover Design !

My design is very simple. I have 2 routers RA and RB connected via 2 serial links. now in normal cases of site to site vpn i will establish peering between RA and RB on any of these serial links ip addresses. but i want to peer between some GLOBAL ip on both of these routers to ensure transparent redundancy !!

i hope this clarifies

146
Views
0
Helpful
4
Replies