Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VRF and next-hop selection using Policy Based Routing.

Hello.

I'm using a Catalyst 6500 with SUP720/MSFC3 and software 12.2(18)SXF7.

I need to select a next-hop into a VRF using PBR, but with this version I can only set, or clear, DF bit.

I believe I need to upgrade my software to use the feature multi-VRF selection using PBR.

sw-core(config-if)# ip policy route-map MR-VS-RER

% Policy Based Routing is NOT supported for VRF interfaces
% IP-Policy can be used ONLY for marking (set/clear DF bit) on VRF interfaces
sw-core(config-if)#

Can somebody confirm this?

Thanks.

Regards.

Andrea

1 REPLY
Hall of Fame Super Blue

Re: VRF and next-hop selection using Policy Based Routing.

andrea.meconi@compaq.com

Hello.

I'm using a Catalyst 6500 with SUP720/MSFC3 and software 12.2(18)SXF7.

I need to select a next-hop into a VRF using PBR, but with this version I can only set, or clear, DF bit.

I believe I need to upgrade my software to use the feature multi-VRF selection using PBR.

sw-core(config-if)# ip policy route-map MR-VS-RER

% Policy Based Routing is NOT supported for VRF interfaces
% IP-Policy can be used ONLY for marking (set/clear DF bit) on VRF interfaces
sw-core(config-if)#

Can somebody confirm this?

Thanks.

Regards.

Andrea

Andrea

Correct, Multi-VRF selection using PBR was first available in 12.2(33)SXH1 so you need to upgrade to that IOS or a later version.

Jon

739
Views
0
Helpful
1
Replies
CreatePlease to create content