Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

vrf-light in my Switch 3750

Hi ,
i try to configure vrf-light in my two Switch 3750E ,
Firstly i try with the vesion (12.2(35)SE5  C3750E-UNIVERSAL-M ) .
the vrf is supported but when i went to configure EIGRP per vrf i had the message following :
FED_B(config)#router eigrp 1
% Remove all VRFs before configuring EIGRP
secondary , i upgrade the version to ( 12.2(53)SE1 C3750E-UNIVERSALK9-M )
but  this version is not supported by vrf-light . I had the message following when i try to configure  vrf-light :
FED_B(config)#ip vrf USER
                  ^
% Invalid input detected at '^' marker.


FED_B(config)#ip v?
verify
what can i do to configure vrf-light and the EIGRP per vrf ( for the load balacing)
Everyone's tags (3)
2 REPLIES
VIP Super Bronze

Re: vrf-light in my Switch 3750

Hi Mohamed,

VRF is defiantly supported on that image.  You many not have the correct license.  Get with SE  or sales guy to provide you with the key to enable it.

do a "sh licen" to see if you have the correct license.

Switch-B#sh license
Index 1 Feature: ipservices    
        Period left: 0  minute  0  second 
        License Type: Evaluation
        License State: Active, Not in Use, EULA accepted
        License Priority: Low
        License Count: Non-Counted

HTH

Reza

New Member

Re: vrf-light in my Switch 3750

Hi Reza,

thanks for your reply , i will try that.

thanks

1966
Views
0
Helpful
2
Replies
CreatePlease to create content