Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VRF-lite and existing EIGRP process

Hello All,

I want to configure VRF-lite and using EIGRP as routing protocol. It's going to be implemented on an existing configuration whereas EIGRP is configured in the global IP routing. What is the best practice of implementing this? Can I configure an address family within the existing EIGRP process, should I create a new one or is both possible and what is the advantage/disadvantage?

Thanks in advance!

  • LAN Switching and Routing
2 ACCEPTED SOLUTIONS

Accepted Solutions
VIP Super Bronze

Hi,You can use the existing

Hi,

You can use the existing one and just add address-family vrf to it.  This way, there is less configuration involved:

so, if your EIGRP id is 100, you can add:

address-family ipv4 test

network 10.10.10.0 0.0.0.255

network 20.20.20.0 0.0.0.255

auton-system 100

exit

You want to make sure you do this during a maintenance windows as it will cause outage.

HTH

 

Hello Depends what you mean

Hello

Depends what you mean by adding vrf to existing eigrp?

If you mean changing the current eigrp peering into a vrf then yes it will cause an outage

however..

If you mean introducing vrf lite on these routers new physical interfaces and using the existing eigrp protocol over the top then
I agree with you this wont cause an outage too the current global eigrp adjacencies - as my understanding vrf utilises its own control/data planes for path determination and forwarding.

 

res

Paul
 

Please don't forget to rate any posts that have been helpful. Thanks.
4 REPLIES
VIP Super Bronze

Hi,You can use the existing

Hi,

You can use the existing one and just add address-family vrf to it.  This way, there is less configuration involved:

so, if your EIGRP id is 100, you can add:

address-family ipv4 test

network 10.10.10.0 0.0.0.255

network 20.20.20.0 0.0.0.255

auton-system 100

exit

You want to make sure you do this during a maintenance windows as it will cause outage.

HTH

 

New Member

Thanks Reza!I agree I should

Thanks Reza!

I agree I should do this during a maintenance window, but are you sure adding above configuration wil cause een outage in the global routing instance. I tried it in a lab and it didn't.

Erik

Hello Depends what you mean

Hello

Depends what you mean by adding vrf to existing eigrp?

If you mean changing the current eigrp peering into a vrf then yes it will cause an outage

however..

If you mean introducing vrf lite on these routers new physical interfaces and using the existing eigrp protocol over the top then
I agree with you this wont cause an outage too the current global eigrp adjacencies - as my understanding vrf utilises its own control/data planes for path determination and forwarding.

 

res

Paul
 

Please don't forget to rate any posts that have been helpful. Thanks.
New Member

Hi,I meant the second

Hi,

I meant the second scenario. Thanks for completing the answer.

Gr,

Erik

169
Views
0
Helpful
4
Replies
This widget could not be displayed.