Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VRF , Management access only and default gateway

Hello

I am preparing (3) new devices to become my new WAN. The topology looks like,

                 ASR1002x - Has management int and dg for remote access.

                                     Also has DG to WAN ISP via BGP

 

                 3750x stack - Has management int and dg for remote access.  (ip vrf management 0.0.0.0 0.0.0.0 (Management vlan hsrp ip))

                                       Also has DG to ASR hsrp - which causes the Management access to drop.

 

                 ASA5545x - Has management int and dg for remote access.

                                      Also has DG to ASR hsrp - which causes the Management access to drop.

 

I MUST KEEP THESE NEW DEVICES OFF THE PRODUCTION NETWORK TO AVOID ANY POSSIBLE ROUTING ISSUES.

I have implemented unique EIGRP instances between the new devices.

 

These new devices have a management interface so I can access them remotely. I configured the default gateway pointing to the HSRP of the management Vlan and I have remote access.

 

Obviously I cannot have (2) default gateways out different interfaces, without assigning one with higher admin.

What should my management default gateway look like so I can have remote access to the device and still have the WAN/LAN routing work as needed??

 

 

 

sMc
55
Views
0
Helpful
0
Replies
CreatePlease to create content