Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VRF NAT Translation / Port Translation

I recently moved the subnet 10.0.50.0/24 into a VRF.  After doing so I realized this broke one of my NAT translations:

ip nat inside source static tcp 10.0.50.230 22 interface GigabitEthernet1/1 9022

I located the following document: http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipaddr_nat/configuration/xe-3s/nat-xe-3s-book/iadnat-match-vrf.pdf

It shows different types of NAT translations for VRF's, but not what I am looking to do exactly.  Can someone assist me in getting the above NAT translation to work with a host that is in a VRF?

Thanks!

Everyone's tags (1)
1 REPLY
New Member

Hi Jeffrey,I'm not the most

Hi Jeffrey,

I'm not the most familiar with this situation, but I've found this thread on the learning network referring to simply adding "vrf <vrf_name>" at the end of the command to specifically tell it to only operate on that VRF. https://learningnetwork.cisco.com/thread/44189

I hope this helps even a little

- Marcus 

19
Views
0
Helpful
1
Replies