We have two core 6509's running VRF. We are required to remove VRF from these, but we are uncertain of the best procedure and practive, and most importantly , the least impact, as we've never removed VRF b4. As these units act as Primary/Secondary units can we have one unit vrf and the non-vrf as we remocve vrf from the configs, so we have no outage on the routing.
I assume you are referring to removing the VRF configuration from the interface.
If the vrf's are not catering to any business then i dont think there would be any problem when you remove them. The IP address from the interface is removed when you configure VRF forwarding but not sure whether the same happens when you remove them.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.