I'm just starting to learn about route leaking today, so I'm still trying to figure this out.
In short, I've created three vlans and put them in a vrf and would like them to access the internet. At this point, I have vrf created, vlans assigned and a global route leaked from the vrf to the gateway of last resort. A machine in the vrf is able to ping all three vlan gateways, but cannot still get to the internet.
I have everything on a 6509 core switch, and my firewall is an ASA 5505. I've also tried putting routing configs in using eigrp, but the vrf networks never made it to the ASA. Attached are my configs on both. If anyone could help me with what I'm missing that would be great. Thanks!
**** 6509 Config ****
Current configuration : 22128 bytes
! Last configuration change at 17:31:43 pst Tue Jan 7 2014 by rmf
! NVRAM config last updated at 12:30:19 pst Tue Jan 7 2014 by rmf
upgrade fpd auto
no service pad
service timestamps debug datetime msec localtime show-timezone
service timestamps log datetime msec localtime show-timezone
no service password-encryption
service counters max age 5
boot system flash disk0:s72033-ipservicesk9_wan-mz.122-33.SXI.bin
aaa authentication login default local
aaa authorization exec default local
aaa session-id common
clock timezone pst -8
clock summer-time PDT recurring
ip dhcp excluded-address 192.168.80.1 192.168.80.9
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...