Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

VRF Routing Issue

Hi guys,

I'm having problems implementing a vrf on a 3560G (12.2(55)SE9, C3750-IPSERVICESK9-M). I have a number of SVI's configured on the switch and I want to separate routing from one (to start) vlan from the rest.

I think my config looks ok, but when testing the traffic seems to die on the vlan interface. My config looks like this:

ip vrf red
 rd 1:1
!
interface Vlan11
 description Block 1 Guest WLAN
 ip vrf forwarding red
 ip address 172.16.5.2 255.255.255.0
!
ip route vrf red 0.0.0.0 0.0.0.0 GigabitEthernet2/0/1 10.201.29.1
ip route vrf red 8.8.8.8 255.255.255.255 GigabitEthernet2/0/1 10.201.29.1

The 10.201.29.1 is an ASA firewall.

What am I missing!?!

Thanks.

edit: It just occurred to me that the exit interface (when traffic returning) won't know about the interface that's not in the global rib and I would need to route back from the global rib to the vrf?

 

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

If you add the route back

If you add the route back into the global routing table it will solve the return route issue.

2 REPLIES
New Member

If you add the route back

If you add the route back into the global routing table it will solve the return route issue.

Hello Just like to add you

Hello

 

Just like to add you don't need both those statics pointing your FW , Just the default route would do

 

res

Paul

Please don't forget to rate any posts that have been helpful. Thanks.
76
Views
0
Helpful
2
Replies
CreatePlease to create content