05-14-2012 11:27 PM - edited 03-07-2019 06:42 AM
Hi Expert,
I upgraded IOS-XE on 4500E (SUP7L-E) to cat4500e-universalk9.SPA.03.03.00.SG.151-1. I encounter the log when i try to issue write mem commad
% VRF table-id 0 not activeCompressed configuration from 8947 bytes to 2140 bytes[OK]
How about this message? it's serious log? Thanks
Solved! Go to Solution.
05-22-2012 08:23 AM
Hi Roger,
This mesage is caused by a new bug (not resolved yet) :
CSCtw93140 On 'wr mem' command noticed "% VRF table-id 0" message
Symptom:
Typing wr mem while using an ipbase or lanbase boot level of IOS-XE causes this message to appear on the console .
Conditions:
No specific condition causes this message to appear other than entering the command.
Workaround:
Currently no workaround exists .
According to the current analysis results on this bug, it is seems to be cosmetic.
Kind Regards,
Ivan
**Please grade this post if you find it useful.
05-22-2012 05:35 AM
Hi Experts,
got the same problem (same HW / SW). Additional there is a temporary high CPU and poor reachability using management port fastEthernet1.
05-22-2012 08:24 AM
Hi Odamis,
This is new bug CSCtw93140, not resolved yet but so far seems to be cosmetic. See above for more details.
Kind Regards,
Ivan
**Please grade this post if you find it useful.
05-22-2012 08:23 AM
Hi Roger,
This mesage is caused by a new bug (not resolved yet) :
CSCtw93140 On 'wr mem' command noticed "% VRF table-id 0" message
Symptom:
Typing wr mem while using an ipbase or lanbase boot level of IOS-XE causes this message to appear on the console .
Conditions:
No specific condition causes this message to appear other than entering the command.
Workaround:
Currently no workaround exists .
According to the current analysis results on this bug, it is seems to be cosmetic.
Kind Regards,
Ivan
**Please grade this post if you find it useful.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: