Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VRRP and MAC address issue

We have 2 switches (Switch 1 & 2) on our end and another 2 switches (Switch 3 & 4) on another end.

Tried running VRRP on Switch 1 & 2, but there seemed to be some mac address issue when failing over (Suspect a spanning port blocking issue)

Is the attached setup valid ?

Is there a way to set up redundancy using the 2 MetroEthernet lines.

2 REPLIES

Re: VRRP and MAC address issue

What is the error you have encountered in switch 1 and 2 and redundancy can be achived by top two switches itself.

Regards

Ganesh.H

New Member

Re: VRRP and MAC address issue

I was told there isn't a problem on our end, but rather the problem happened over Sw 3 and 4 which is not managed by us. I suspect that the one of the ports was in blocking mode. Could I be right in my suspicion?

Bear in mind that the Vlan 123 are over MetroEthernet lines.

268
Views
0
Helpful
2
Replies