Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

vrrp groups between nortel passport and cisco cat 6500

Hi all, I wish to migrate a site to some cat 6500 from nortel passport, the passport has about 40 vrrp groups configured, 1 for each vlan, they are all active on one router. they range from 1000 to 1010 for the group numbers , my question is how can I do this on the cat 6500, can I use these same group numbers for smooth migration ?

1 REPLY
Bronze

Re: vrrp groups between nortel passport and cisco cat 6500

VRRP is an open standard meant to allow different vendors to be involved. RFC3768 & 2338 cover the specifics.

To enable VRRP, use the vrrp command in configuration mode. Use the no form of the command to revert to the factory defaults or to negate a command.

vrrp ipv4-vr-group-number

{address ip-address [secondary] |

advertisement-interval seconds |

authentication {md5 keyname spi index | text password} |

preempt |

priority value |

shutdown |

track interface {mgmt 0 | vsan vsan-id}

http://www.cisco.com/en/US/products/hw/vpndevc/ps2284/products_tech_note09186a0080094490.shtml covers some more info

hth

528
Views
0
Helpful
1
Replies