Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

VRRP issue

Hi,

For redundancy I use the command VRRP. I have configured the following

track 1 interface FastEthernet4.6 line-protocol
track 2 ip route 0.0.0.0 0.0.0.0 reachability

Now, I want also add a new track. This track need to check if a specific IP is still alive.

Is this possible and what is the config?

Best regards, Wim

1 REPLY
Bronze

VRRP issue

For this functionality you will need to track based on IP SLA.

With IP SLA you can track the status of a far-end IP address to determine if it is up and alive.

When implemented with tracking, you can now trigger certain events based on the reachbility of that IP address.

Here is a Cisco guide with some more information:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750x_3560x/software/release/12.2_55_se/configuration/guide/sweot.html#wp1085002

114
Views
5
Helpful
1
Replies
CreatePlease to create content