I am a newbie creating a new VRRP environment. R1 and R2 will form VRRP with R1 as the master with priority 110 while R2 as the slave with priority 100.
Every thing is fine when all routers is running up. When R1 is shutdown and R2 took over as master, everything is also fine. However when you shutdown R2 and R1 takes over as master (which is also true since it is configured with a higher priority), then client PC cant ping and pass thru.
Pls help to advice and troubleshoot.
I have configured the environment in GNS3 and can share the DropBox if you provide an email reply.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...