06-17-2009 09:19 PM - edited 03-06-2019 06:19 AM
hi
i have 2 x c6509e, each equiped with 1 x VS-S720-10G(with 2 x 10g port), i need to confiure portchannel with both 10g port between this two c6509e, and need to use standalone mode only(not VSS), however i found error disable from one side of switch after enabled the portchannel from 10g port,
i checked all fiber cable work fine, if not use portchannel configure, i can bring up both 10g port those switches,
here's the port channel configure(identical from both c6509e):
interface Port-channel1
switchport
switchport trunk encapsulation isl
switchport mode trunk
interface TenGigabitEthernet5/4
switchport
switchport trunk encapsulation isl
switchport mode trunk
channel-group 1 mode on
!
interface TenGigabitEthernet5/5
switchport
switchport trunk encapsulation isl
switchport mode trunk
channel-group 1 mode on
IOS Version 12.2(33)SXH4
06-18-2009 12:40 AM
Hello Tat,
try to use 802.Q encapsulation
may you post the error message you can find it with
sh log
Hope to help
Giuseppe
06-18-2009 04:48 AM
i do not know what is happen, but after upgrade to 122-33.SXH5.bin, the portchannel is work fine for 10g port,thanks!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: