ā05-06-2010 11:17 AM - edited ā03-06-2019 10:58 AM
Hello,
One Question...
Do i really need to use a port channel for my vsl link ?
can i just take one TenGig interface on each supervisor
and put the virtual switch link ... command on each interface
... without creating the Port-Channel ?
thanks
ā05-06-2010 11:22 AM
desrochj1 wrote:
Hello,
One Question...
Do i really need to use a port channel for my vsl link ?
can i just take one TenGig interface on each supervisor
and put the virtual switch link ... command on each interface
... without creating the Port-Channel ?
thanks
You can use a single link but VSS is designed to be a highly available system so using a single link is introducing a single point of failure into the system.
Jon
ā05-06-2010 11:56 PM
Hello,
One Question...
Do i really need to use a port channel for my vsl link ?
can i just take one TenGig interface on each supervisor
and put the virtual switch link ... command on each interface
... without creating the Port-Channel ?
thanks
Hi,
It's always a better recommendation to have vsl link with port channel configuration, check out the below link for more information
http://www.cisco.com/en/US/products/ps9336/products_tech_note09186a0080a7c837.shtml#vss_best
Hope to Help !!
Ganesh.H
Remember to rate the helpful post
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: