I would like to implement VSS on my Datacenter. I have a 6500 working standalone and I have servers and access switches connected to it. My question is what happen with the configuration of this switch at the moment that I restart it to implement VSS with my brand new 6500.
By example what happen with the config of interfaces in module 3 (G3/1, 3/2 ....etc) when it becomes G1/3/1, 1/3/2...etc. It will keep the config or I have to reconfigure it?
In VSS configruation of the both the switches will be merged into single configuration and the interfaces will be perfixed with switch1 / switch 2. For example, the interface 1/5/4 command specifies port 4 of the switching module in slot 5 of switch 1. The interface 2/5/4command specifies port 4 on the switching module in slot 5 of switch 2.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...