Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VSS dual-active (Port-Channel Pagp)

Anyone knows if is possible to configure multichassis port-channel between a VSS and 3750X (Port-channel not in the same switch on the 3750X stack). I got it using LACP but I need Pagp to get VSL redundancy “dual-active detection pagp trust channel-group 1”. I am using the last VSS IOS version 15.0(1)SY.

I can’t get the option “switch 1 preempt”, anyone knows if has it changed with other option?

Thank you very much, guys, for your help!

2 REPLIES
VIP Super Bronze

VSS dual-active (Port-Channel Pagp)

Oscar,

Unfortunately, PAgP cannot be enabled on cross-stack EtherChannels.  To remedy this problem, use a 1Gig copper port between the 2 VSS switches and utilize the "fast hello" feature instead.

HTH

New Member

VSS dual-active (Port-Channel Pagp)

Hi Reza,

thanks for your answer. I got this:

You can configure trust mode on a port channel even if there are no interfaces on the port channel or the port channel is a protocol type other than PAgP. The trust mode status is displayed in the show pagp dual-active command output, but no interfaces are displayed.

1509
Views
0
Helpful
2
Replies
CreatePlease login to create content