Vss failover takes 10 minutes

[ikoritana_sbet]

Hi,

We have a two 6509 chassis in vss mode (122-33.SXI6).

Currently a 'redundancy force-switchover' takes 10 minutes to complete (before we can access switch on management IP).  We are running sso with nsf.  Is this expected given standad HSA and we arent/cant run  RPR/+.

[Reza Sharifi]

Hi,

That is not the correct behavior.  When you issue "'redundancy force-switchover" it usually takes less than a second for the other switch to take over and become the primary switch.  Can you post your config?

HTH

[Reza Sharifi]

Also, can you post the output of " show switch virt detail"?

[ikoritana_sbet]

Is this what you need ?

MAL2-PR-SW01-1#sh swi virtual role detail ?

  |  Output modifiers

MAL2-PR-SW01-1#sh swi virtual role detail

Switch  Switch Status  Preempt    Priority  Role     Session ID

        Number         Oper(Conf) Oper(Conf)         Local  Remote

------------------------------------------------------------------

LOCAL    1     UP      FALSE(N )   110(110)  ACTIVE   0      0

REMOTE   2     UP      FALSE(N )   100(100)  STANDBY  8548   2400

RRP Counters:

--------------------------------------------------------------------

Inst. Peer Direction Req       Acc        Est        Rsugg       Racc

----------------------------------------------------------------------

1     1      Tx      0          1          0          1          3

1     1      Rx      2          0          1          0          3

RRP FSM info:

--------------------------------------------------------------------

sm(vslp_rrp RRP SM information for Instance 1, Peer 1), running yes, state role_res

Last transition recorded: (lmac)-> lstart (req)-> hold (srt_exp)-> hold (req)-> hold (est)-> role_neg (srt_exp)-> role_neg (racc)-> role_res (srt_exp)-> role_res (racc)-> role_res (racc)-> role_res (srt_exp)-> role_res (srt_exp)-> role_res

In dual-active recovery mode: No

[Reza Sharifi]

just

show switch virtual

or

show switch virtual detail

HTH

[ikoritana_sbet]

MAL2-PR-SW01-1#               sh switch virtual

Switch mode                  : Virtual Switch

Virtual switch domain number : 100

Local switch number          : 1

Local switch operational role: Virtual Switch Active

Peer switch number           : 2

Peer switch operational role : Virtual Switch Standby

MAL2-PR-SW01-1#

[Reza Sharifi]

Can you delete this command, save the config and test the fail over again?

switch 1 priority 110

HTH

[ikoritana_sbet]

It now takes 30 seconds

[Weezy-F]

I'm experiencing same issues on our cisco 9500-40x. Any suggestions? to fix

[ikoritana_sbet]

Attached config

[Weezy-F]

I'm experiencing same issues on our cisco 9500-40x. Any suggestions? to fix