Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VSS FWSM Config

Hi,

Please help me on below queries.

Cisco doc says that both FWSM in VSS chasis are active.

I have 5 vlans in my network and assigned all vlans to both FWSM. But i am confused over the FWSM configuration on VSS standby.

1) Whether we need to configure both FWSM individually

2) Is it a must that i should enable active/stanby or active/active  failover in FWSM

3) if i don't enable failover , whether i have to individually configure the FWSM with different Vlan interface IP's and point the routes based on path cost.

Regards,

Savad

269
Views
0
Helpful
0
Replies
CreatePlease to create content