08-13-2010 03:06 AM - edited 03-06-2019 12:27 PM
Hi @all,
I have two Chassi 6509 with SUP720-VSS
the original IOS was an SXI, so now I use s72033-ipbasek9-mz.12.2-33.SXI4a
If i am looking at cisco site to support for "Cisco Catalyst 6500 Virtual Switching System 1440" there is only listed "Catalyst 6500 Release 12.2SXH and Later Software Configuration Guide"- Where is the pdf for the SXI version?
Which IOS is recommended by Cisco for VSS?
If I compare the two Version SXH and SXI with cisco software advisor (it is only available for s72033-ipbasek9-mz.12.2-33.SXI3 and s72033-ipbasek9-mz.12.2-33.SXH6) I see that in the SXI version are more features included.
But I found out that there must be differences in some commands between the SXI and SXH.
As example (Catalyst 6500 Release 12.2SXH and Later Software Configuration Guide):
Router1(config)# switch virtual domain 100
Router1(config-vs-domain)# switch 1 priority 20
Router1(config-vs-domain)# switch 1 preempt 12
in the SXI4a Version there is no preempt command :-/
Solved! Go to Solution.
08-13-2010 03:54 AM
Hello Marcus,
the configuration guide for SXI is that of SXH ( and later releases)
if you make a search about VSS in the forums you will see that most people agree on using SXI on VSS
Hope to help
Giuseppe
08-13-2010 03:54 AM
Hello Marcus,
the configuration guide for SXI is that of SXH ( and later releases)
if you make a search about VSS in the forums you will see that most people agree on using SXI on VSS
Hope to help
Giuseppe
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: