Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VSS issue with 4500x-16 pair

I have just run the vss convert on a pair of 4500x-16 switches, the one switch converted fine but the second failed and went into a boot loop.

I got out of this into Rommon and got the switch to boot. on this switch it now states

sh switch virtual
Switch Mode : Standalone
 Not in Virtual Switch mode due to:
  Domain ID is configured
  This implies an incomplete or failed Virtual Switch conversion process.
 

 

anyone have any ideas how I can get this switch happy with VSS. I followed the config steps directly from the manuals

cheers

 

config attached, just before the convert was attempted, sw0 failed sw1 worked

260
Views
0
Helpful
0
Replies