Dear, Since it was a live environment i had to roll it back to normal mode, however i remember doing "show redundancy" and it was showing me only one active processor. Dont remember if it was showing Simplex mode or not? But incase if it does show Simplex mode even after VSS configuration what does that mean? And what else could have gone wrong? Thanks, Aamir
Dear, yes i also realize that port channel number should be same under the TenGig interface, i guess i made a type error. Also i need to ask in a state where the port channel was configured wrong and switches are in VSS state that is their interface are re-numbered, would changing the port channel and restarting the switches solve the problem or i would have to first convert them in stand alone mode and then do VSS config all over again? Thanks, Aamir
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.