cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4291
Views
11
Helpful
11
Replies

VSS supported in SUP 8

Jonn cos
Level 4
Level 4

Hi all,

I was viewing VSS configuration in latest 4500 switch configuration guide

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/XE3.5.0E/15.21E/configuration/guide/vss.html#wp1053927

Under pre requisite, it says that SUP 7E and 7LE are supported so what about 8-E ? under datasheet its mentioned that it supports VSS

1 Accepted Solution

Accepted Solutions

Correct - Sup 8 does not support VSS with current software (IOS-XE 3.3.0XO) required to use this new module.

Expect that to change in coming months once IOS-XE 3.6.0 is released. Cisco has not announced the exact date yet.

Perhaps you should put it on your Christmas wish list.

Please rate helpful posts and mark your question as answered when it has been.

View solution in original post

11 Replies 11

Richard Michael
Cisco Employee
Cisco Employee

Yes 8-E is VSS supported.

Thanks,

Richard.

*Rate if useful

Sir in above document which is the latest, 8-E is not listed under pre requisite.

Sir pls also refer to below discussion held on 6th september 2013

https://supportforums.cisco.com/thread/2236010

Here also he has clearly mentioned Sup 7E/7LE.

Leo Laohoo
Hall of Fame
Hall of Fame

Agree.  VSS support in Sup8.

Then Sir why its not listed under pre requisites ?

You are referring to the configuration guide for IOS-XE 3.5.0E. That release does NOT support the Sup 8.

For Sup 8 you currently need to use release 3.3.0XO - a branch off of IOS XE 3.3.0SG. See the diagram here in the release notes.

Once 3.6.0XE is released, Sup 8 support will be rolled into the main line and VSS support should be implemented. Currently it is only a ROADMAP (future) capability for the Sup 8. See the note in the Sup 8 data sheet.

Sir that means i am correct that SUP 8-E currently dont support VSS ?

Correct - Sup 8 does not support VSS with current software (IOS-XE 3.3.0XO) required to use this new module.

Expect that to change in coming months once IOS-XE 3.6.0 is released. Cisco has not announced the exact date yet.

Perhaps you should put it on your Christmas wish list.

Please rate helpful posts and mark your question as answered when it has been.

Thanks alot Sir.

it will be better to use Cisco Feature Navigator:

http://tools.cisco.com/ITDIT/CFN/jsp/index.jsp

 

I find Cisco Feature Navigator to be one of the most unwieldy tools on all of cisco.com.

I've been a Cisco customer for 20 years on both the end user and partner side and have difficulty making CFN give me useful information. I can only imagine how difficult it is for a less familiar user.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco