If two switches are in VTP SERVER mode and have the same VTP Domain name, does the swith with the highest revision number control the configuration of the domain? Will a switch in VTP SERVER mode accept the configuration information from another switch?
Yes, if both are in VTP server mode with the same domain name, same password ( if set ) and are connected via a trunk then the switch with the highest configuration revision number will control the config. Obviously this means that once synced you could make the changes on either VTP server as the revision number should be the same.
And yes a VTP server will accept configuration from another VTP server.
It will also accept a config from a client if the revision number is higher and it is in the same vtp domain and has been known to take down networks if you are not careful about putting new devices in .
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...