Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

VTP over back-to-back G.SHDSL

In my company, I am connecting 3 sites by configuring routers with G.SHDSL interfaces at each site. One central with 2 G.SHDSL interfaces and one router with G.SHDSL at each other site. Back-to-back configuration was done using a copper cables running between the 3 buildings. I am trying to run VTP over these transparent linke but it is not working. is there a way?

I managed to configure subinterfaces and carry each VLAN through each subinterface. But I still would like to use VTP to manage VLANs. Any help? Thanks.

1 REPLY

Re: VTP over back-to-back G.SHDSL

Hi

To propogate VTP information u need to have trunk links beteen u r devices.VTP messages will not propogate over L3 links

Thanks

Mahmood

185
Views
0
Helpful
1
Replies
CreatePlease to create content