04-18-2007 06:58 AM - edited 03-05-2019 03:31 PM
I have 3 switches 3750?s connected with Cat5 1000mb I need to set up Vlan?s. I?ve tried to set the vtp on one switch as master and the other two as client but when I create a vlan on the master switch I do not see any on the Client switches am I missing something?
04-18-2007 07:03 AM
Hi Friend,
Make sure you configure trunk between switches. Also make sure you have same VTP domain configured on all switches with same password.
I will recommed to first check the trunk connection between switches.
HTH
Ankur
04-18-2007 10:36 PM
Hi,
a very basic configuration that you have to do in your switches is like that:
conf t
vtp domain TEST (as you wish, but the same)
vtp mode server|client
vlan x
name X
vlan y
name Y
... (and so on)
interface (between switches)
switchport trunk encapsulation dot1q
switchport mode trunk
So, check your trunk, check your VTP configuration, and that's it.
HTH
Andrea
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide