Happy Holidays Everyone.
I have been reading some posts on the forum about WoL packets traversing a LAN to wake up specific IP's.
Basically, as I understand it, I need to add the following to a config for it to work:
ip forward-protocol <udp-port used by WOL application>
ip helper-address <directed broadcast address od the lan where the workstations are>
I also read that I need to configure the subnet where the workstations to be awaken resides with ip directed-broadcast <ACL>. My question is..what would be in that ACL? If I dont use an ACL, what else would I put there?
thanks!
bob