Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WAN router with failover to external VPN device

Cisco 2811 with MPLS running RIPv2. What is the best way to configure VPN failover to another device (Juniper SSG-350) that is on the same LAN? Is this as simple as weighted static route?

  • LAN Switching and Routing
1 ACCEPTED SOLUTION

Accepted Solutions

Re: WAN router with failover to external VPN device

Chip,

It was my typo again. It should be look like this:

ip route 20.0.0.0 255.0.0.0 10.100.100.1(Juniper) 130(AD)

HTH,

Toshi

4 REPLIES

Re: WAN router with failover to external VPN device

Chip,

Just add static routes pointing to Juniper with higher AD than RIP. This should be fine.

HTH,

Toshi

New Member

Re: WAN router with failover to external VPN device

Thanks for the quick response, what did you mean by "then RIP" ?

Thanks!

Re: WAN router with failover to external VPN device

Chip,

It was my typo again. It should be look like this:

ip route 20.0.0.0 255.0.0.0 10.100.100.1(Juniper) 130(AD)

HTH,

Toshi

New Member

Re: WAN router with failover to external VPN device

ok, understand

Thanks for the quick help.

139
Views
0
Helpful
4
Replies