Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WAP321 and SG500 port config

I have several WAP321's running from a SG500-28P switch. I am having problems with these on some devices, I think it is related to roaming, i.e. a wireless client is able to connect to WAP 1 then roams to WAP 2 there device still shows connection, however, they are unable to send/receive any packets, the devices are always able to connect HTTP to the WAP they are connected and the switch, yet traffic flows no further than the switch. Devices on my network that never move (physically) don't seem to be affected by this issue. I have disabled spanning tree on the wireless ports to no avail.

Please advice, many thanks.
 

34
Views
0
Helpful
0
Replies