Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Warm Insertion of WS-SUP32-GE-3B in C6509

Even though we know most of the modules are warm insertable (hot swapable), are there any experience, comment or recommendation about inserting a WS-SUP32-GE-3B (the second supervisor) on Warm?.

Thanks in advance,

Juan Salgado

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Silver

Re: Warm Insertion of WS-SUP32-GE-3B in C6509

Hello Juan,

you can install the sup on the live chassis, take care of electostatic charges connecting your body to the chassis

see

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Config_Notes/78_16999.html

Your own ESD-prevention equipment or the disposable grounding wrist strap included with all upgrade kits, field-replaceable units (FRUs), and spares

Hope to help

Giuseppe

Hope to help

Giuseppe

Hall of Fame Super Gold

Re: Warm Insertion of WS-SUP32-GE-3B in C6509

Hi Juan,

Just make sure the IOS of the new Sup blade is the same with the current one. Also make sure that there is NO configs available.

6 REPLIES
Hall of Fame Super Silver

Re: Warm Insertion of WS-SUP32-GE-3B in C6509

Hello Juan,

you can install the sup on the live chassis, take care of electostatic charges connecting your body to the chassis

see

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Config_Notes/78_16999.html

Your own ESD-prevention equipment or the disposable grounding wrist strap included with all upgrade kits, field-replaceable units (FRUs), and spares

Hope to help

Giuseppe

Hope to help

Giuseppe

New Member

Re: Warm Insertion of WS-SUP32-GE-3B in C6509

For sure it helps.

Thanks a lot. I just needed that little trust from your experience.

Juan Salgado

Hall of Fame Super Gold

Re: Warm Insertion of WS-SUP32-GE-3B in C6509

Hi Juan,

Just make sure the IOS of the new Sup blade is the same with the current one. Also make sure that there is NO configs available.

New Member

Re: Warm Insertion of WS-SUP32-GE-3B in C6509

Great recomendations.

Thanks a lot.

Juan Salgado

Re: Warm Insertion of WS-SUP32-GE-3B in C6509

No problem Jaun done it a ton of times. Just watch the ESD.

Hall of Fame Super Gold

Re: Warm Insertion of WS-SUP32-GE-3B in C6509

Thanks for the ratings, Juan.

195
Views
0
Helpful
6
Replies