Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WCCP with HTTPS

I'm trying to configure WCCP between Cisco Cat4507 & bluecoat , it is working fine for HTTP but not for HTTPS . The following is my configuration

BlueCoat :

wccp enable

wccp version 2

service-group web-cache

forwarding-type L2

assignment-type mask

mask-scheme destination-ip

interface 0:0

home-router X.X.X.X

end

Cat4507 :

ip wccp web-cache

interface Vlan18

ip address X.X.X.X X.X.X.X

ip helper-address X.X.X.X

ip wccp web-cache group-listen

no ip route-cache cefend

interface Vlan51

ip address X.X.X.X X.X.X.X

ip helper-address X.X.X.X

ip wccp web-cache redirect in

no ip route-cache cef

no ip route-cacheend

Is it related to the service-group ?

3 REPLIES

Re: WCCP with HTTPS

You need to enable Https cache service (service 70).This service permits WCCP Version 2 enabled devices to redirect HTTPS traffic to CEs.

(config)# ip wccp 70 <-- To turn on service 70

(config)# int

(config-if)# ip wccp 70 redirect {in|out}

New Member

Re: WCCP with HTTPS

Iftekhar,

Thanks for your replay .

Do I need to use the following command

* ip wccp 70 group-listen under the interface link to the BlueCoat , if yes

How can i enable several service group in bluecoat ?

Thanks

Re: WCCP with HTTPS

I am not familiar with bluecoat.Probably you should try forums on their website :).

Just to clear things up

On WCCP capable routers/switches you need to configure different services to redirect different traffic.

For example

(Web = service 0 also called web-cache)

(SSL - Service 70) (DNS Service 53) (Reverse proxy - Service 99) (FTP native - service 60) etc..

"ip wccp web-cache redirect in" commmand in your case is redirecting web traffic to the configured "service-group" (which is by defination cluster of CEs).

"ip wccp web-cahe group-listen" command is used to configure an interface on a WCCP V2 router to enable the reception of IP multicast packets.

Syed Iftekhar Ahmed

890
Views
0
Helpful
3
Replies