My 2610 had been participating just fine in my little OSPF lab; I went into config-if mode and gave its Eth0 interface the ip address I wanted. Then I realized I needed to re-assign the addresses in its area; and suddenly when I give the
config)# int e0
command, it says "%Incomplete command." I've tried every variation of what the "?" facility says I should say in global config mode; and still with the "%Incomplete command" message.
This also now occurs when I do a "show interface e0" command in EXEC mode (user or privileged).
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.