Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

What am I doing wrong?

I have just go a new 2911, it has 3 GB interfaces. the first gi0/0, is configured for WAN access and gi0/1 is configured as a LAN. Now when I try to access the internet from the LAN interface it just fails, I can ping the internet from the WAN interface but not from the LAN interface. Can someone have a look at my config and let me know "What am I doing wrong?"

interface GigabitEthernet0/0

description $ETH-SW-LAUNCH$$INTF-INFO-GE 0/0$$ETH-WAN$$FW_OUTSIDE$

ip address 194.73.xxx.xxx 255.255.255.192

no ip redirects

no ip unreachables

no ip proxy-arp

ip verify unicast reverse-path

ip flow ingress

ip nat outside

ip virtual-reassembly

duplex auto

speed auto

no mop enabled

!

!

interface GigabitEthernet0/1

description $ES_LAN$$ETH-LAN$$FW_INSIDE$

ip address 172.19.20.1 255.255.255.0

no ip redirects

no ip unreachables

no ip proxy-arp

ip flow ingress

ip nat inside

ip virtual-reassembly

duplex auto

speed auto

no mop enabled

!

!

ip route 0.0.0.0 0.0.0.0 194.73.xxx.xxx

1 REPLY
VIP Super Bronze

What am I doing wrong?

Can you also post your NAT statment and access list?

163
Views
0
Helpful
1
Replies
CreatePlease to create content