Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

What does 'FpdUpRqd' in the module status of a 7604 mean?

the 7604 is running 12.2(33)SRB2, and I installed a SIP-400 in slot 4. The status showed OK until I then installed a 2-port GE SPA into the SIP and now the status is FpdUpRqd. Does this mean something needs to be updated?

Here is the output of 'show mod':

ROC-RT7604B-CR#sh mod

Mod Ports Card Type Model Serial No.

--- ----- -------------------------------------- ------------------ -----------

1 2 Supervisor Engine 720 (Active) WS-SUP720-3B SAL1106GLFB

2 0 4-subslot SPA Interface Processor-400 7600-SIP-400 JAE1115C0HV

4 0 4-subslot SPA Interface Processor-400 7600-SIP-400 JAE1217G9WB

Mod MAC addresses Hw Fw Sw Status

--- ---------------------------------- ------ ------------ ------------ -------

1 0016.c85e.75ec to 0016.c85e.75ef 5.3 8.4(2) 12.2(33)SRB2 Ok

2 0017.952e.b520 to 0017.952e.b59f 2.4 12.2(33)SRB2 12.2(33)SRB2 Ok

4 001f.cac1.0a40 to 001f.cac1.0abf 2.5 12.2(33)SRB2 12.2(33)SRB2 Ok

Mod Sub-Module Model Serial Hw Status

---- --------------------------- ------------------ ----------- ------- -------

1 Policy Feature Card 3 WS-F6K-PFC3B SAL1106GF7B 2.3 Ok

1 MSFC3 Daughterboard WS-SUP720 SAL1105G0WE 2.6 Ok

2/0 2xGE SPA SPA-2X1GE JAE1115C828 2.2 Ok

4/0 2xGE SPA SPA-2X1GE JAE1210ADJ2 2.2 FpdUpRqd

1 REPLY

Re: What does 'FpdUpRqd' in the module status of a 7604 mean?

This means that slot 4/0 is a Field Programmable device, and the firmware needs to be updated. There is a manual, and an automatic way at updating the firmware.

Automatically

upgrade fpd auto

Manually

upgrade hw-module slot 4 file disk0:c7600-fpd-pkg.122-33.SRA-B.pkg

Here is a guide that will also help.

http://www.cisco.com/en/US/products/hw/routers/ps368/module_installation_and_configuration_guides_chapter09186a008044035b.html

Mark

1226
Views
0
Helpful
1
Replies
CreatePlease to create content