Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

what for the command sw 1 priority 15 is used

what for the command sw 1 priority 15 is used

1 REPLY
New Member

what for the command sw 1 priority 15 is used

This will set the priority for the stack election.  If you want a particular switch to be the master switch in the stack you would set the priority higher than the default (which is 1).

Also, you could set a sequence in case of a failure as well.  For example, if you had a stack of 6 switches, you could designate one as master (priority 15), a backup (priority 14) and even a tertiary backup (priority 13); this way if there was a failure the election process won't have to determine the master switch.

554
Views
0
Helpful
1
Replies
CreatePlease to create content