Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

what is Management VLAN ???

what is Management VLAN ???

2 REPLIES
New Member

Re: what is Management VLAN ???

Hi Vinothlb1,

A managementvlan is a vlan where you do management of you switches / routers / network devices. Via this vlan you do the telnet / http sessions, snmp traffic is sent via this vlan. You can configure to do the vtp updates via this vlan. If you don't do extra configuration most of the switch packets like vtp/cdp are flowing over vlan 1.

Cheers

Jorg

Re: what is Management VLAN ???

A Management VLAN is now a bit of a loose description. Previously switches were only Layer-2 and couldn't 'route' packets between VLANs - this was the job of Core Routers where your VLAN trunks would terminate. These Layer-2 switches however still required remote management - i.e. an IP interface you can telnet to, send SNMP requests to, receive SNMP traps & Syslog from etc. It is the entry point to the management interface of the switch. It was previously best practise to keep this interface on a separate VLAN than User traffic.

Now however having flat layer-2 switched networks is not the way you should be deploying campus networks as they simply aren't scalable and since 99.9% of traffic is IP is can be routed as quick as it can be layer-2 switched.

With Cisco switches control-plane traffic such as DTP, VTP & PaGP is ALWAYS sent on VLAN trunks with a tag of 1 and this cannot be changed. Management traffic (traffic to the Managment Interface of the switch) is sent on whatever VLAN you happen to have an SVI that is reachable on the switch. With Layer-2 only switches only one SVI can ever be active, with Layer-3 switches you can have multiple active SVI's since it is effectively a router.

Have a read of the Campus SRND's - http://www.cisco.com/go/srnd

HTH

Andy

126
Views
0
Helpful
2
Replies
CreatePlease to create content