What is the purpose of bandwidth inherit command ?
The bandwidth command on a router/switch, is just a logical value, that processes on the router use to calculate, things such as Routing Protocol Metrics, QoS, etc.
By setting 'bandwidth 16000', this will not set the interface to 16Mbps, for this you will need to either shape/police depending on which direction you are going, and if you are connected to a Service Provider on this port.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...