Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

What is the second, third, etc. next-hop address in the route-map set command for?

 

What is the second, third, etc. next-hop address in the route-map set command for?

route-map TEST_PBR permit 10 match

match ip address 101

router(config-route-map)#set ip next-hop 1.1.1.1 ?

A.B.C.D IP address of next hop

1 REPLY
Cisco Employee

 Hi, You may get your answer

 

Hi,

 

You may get your answer in below link

 

http://www.groupstudy.com/archives/ccielab/200812/msg00999.html

 

First next-hop will be used unless until that is not unreachable. If first is unreachable, then next one will be used. Since these next-hops are directly connected, router can easily come to know whether they are active or not. In case you want to set some loopback ip as next-hop then you need to use keyword recursive "set ip next-hop recursive"

 

--Pls dont forget to rate helpful posts--

Regards,

Akash

65
Views
5
Helpful
1
Replies