Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

What key sequence to go into ROMMON from the console port for VSS with VS-S720-10G?

What key sequence to go into ROMMON mode from the console port for VSS system with 2 VS-S720-10G?

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

What key sequence to go into ROMMON from the console port for VS

You need to have console connected to redundant SUP. Once it will be start rebooting and show first symbols you can type Ctrl+Break continiously to break into rommon.

Hope this helps,

Nik

3 REPLIES
New Member

What key sequence to go into ROMMON from the console port for VS

I'd like to go to ROMMON mode for the standby supervisor card.

After the redundancy reload peer comande

#redundancy reload peer

Cisco Employee

What key sequence to go into ROMMON from the console port for VS

You need to have console connected to redundant SUP. Once it will be start rebooting and show first symbols you can type Ctrl+Break continiously to break into rommon.

Hope this helps,

Nik

New Member

What key sequence to go into ROMMON from the console port for VS

Thank you, the serial port of Supervisors is connected to a Cyclades console server.

The break séquance is:

%break and "Carriage return"

2002
Views
0
Helpful
3
Replies
CreatePlease login to create content