02-09-2012 12:44 PM - edited 03-07-2019 04:50 AM
If I have an ip address of a server on a remote switch how do I find out what port it is on?? I know I can get the Mac of the server and look at the Mac table but what if I only have ip. I used to get this but can't remember what I did. I console into switch and ping it but no entries in arp table.
Thanks
Gene
Sent from Cisco Technical Support iPhone App
02-12-2012 05:33 PM
anyone have some input on this????!
Sent from Cisco Technical Support iPad App
02-12-2012 05:56 PM
With ip only:
Log on the L3 device and do 'show ip arp
If you have only one switch and router then you know the exercise.
hth
MS
02-13-2012 06:00 AM
Thanks!!!! I knew I was missing something and just forgot.....need to be on the L3 not L2 switch....sometime the most obvious is overlooked. Thanks for the kick in the butt.....:-))
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide