cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
258
Views
0
Helpful
1
Replies

What Triggers This Trap fro CatOS Devices?

slcornish
Level 1
Level 1

All,

Does anyone know what configuration statements triggers this trap?

private.enterprises.cisco.workgroup.1.1.34.0 (OctetString): Module 2 block changed by SecurityRx//

1 Reply 1

Not applicable

Here is some information on the set snmp trap.

Issue the set snmp trap command to enable or disable the different SNMP traps on the system. The command also adds an entry into the SNMP authentication trap receiver table.

Syntax

set snmp trap {enable | disable} [all | auth | bridge | chassis | config | entity | entityfru | envfan | envpower | envshutdown | ippermit | module | repeater | stpx | syslog | system | vmps | vtp]

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card