Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

whats the benefit of using dhcpv6 , if i am able to assign using pools ??

hi ,

i have an ipv4  network and my side seems as adsl provider ,

my clients user pppoe and get ipv4

currently im trying to use ipv6 ,

currently im in testing mode ,

i want to assing  ipv6  ips  to users that uses broadband connection , i mean that now i dont need to use prefix delegation ,

but ,  if i am able to use  and assing ipv6 ips using  pool command

""""peer default ipv6 address pool testpool"""

why we use dhcpv6 statless ???

here is my current config

Bras2#sh running-config interface virtual-template 1

Building configuration...

Current configuration : 400 bytes

!

interface Virtual-Template1

ip unnumbered Loopback1

ip wccp 60 redirect in

ip tcp adjust-mss 1412

ip policy route-map private

no logging event link-status

ipv6 unnumbered Loopback2

ipv6 mtu 1492

no ipv6 nd ra suppress

ipv6 dhcp server vvv

peer default ip address pool st1 st2 st3 st4

ppp mtu adaptive

ppp authentication pap vpdn

ppp authorization vpdn

ppp accounting vpdn

end

===============================================

note that current config of dhcpv6 above not wotrking !!!!

Q1-which to clarify why we need dhcpv6

also

Q2-why current above config of dhcp v6 not working ???

regards

119
Views
0
Helpful
0
Replies
CreatePlease to create content