Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Whatsup Gold & SNMP Configuration

What all has to be configured in a cisco router to get the SNMP logs in Whatsup gold software?

1 REPLY
New Member

Re: Whatsup Gold & SNMP Configuration

Hello,

Whatsup Gold supports SNMP v1-3.

If you use v1 or v2c, in order to get MIBs from a router or  switch

only you need to configure are ip address and following  line

in global configuration mode.

"snmp-server community "

If  you need specific requirement other than just getting MIBs,

you  can find information about snmp part in following urls.

You can easly find documents for your IOS  version or for products from here.

http://www.cisco.com/univercd/home/home.htm


Select your IOS release and go "Configuration Guide and  Command Reference",

then you can see "Network  Management  Configuration Guide" there.

e.g. "Network  Management  Configuration Guide" of IOS 12.4 is here.

Cisco  IOS Network Management Configuration Guide, Release 12.4

Configuring SNMP Versions 1  and 2

http://www.cisco.com/en/US/docs/ios/netmgmt/configuration/guide/nm_cfg_snmp_sup_ps6350_TSD_Products_Configuration_Guide_Chapter.html#wp1200341

Cisco  IOS Network Management Configuration Guide, Release 12.4

Configuring SNMP Version  3

http://www.cisco.com/en/US/docs/ios/netmgmt/configuration/guide/nm_cfg_snmp_sup_ps6350_TSD_Products_Configuration_Guide_Chapter.html#wp1201017

Regards,

Kimihito.

2996
Views
0
Helpful
1
Replies